Senior Instrumentation and Control Engineer-Qatar

McDermott International, Qatar                               Qualification:

• Bachelor’s Degree in Electrical, or Electronics and Instrumentation Engineering (Master’s Degree is preferred). Preferably Registered Professional Engineer or member of a professional engineering society.

Experience:

• 7-10 years in oil and gas with a major contractor or consultant predominantly performing detail design.
• Strong working knowledge of many design techniques and analysis methods, and detailed knowledge of the content and application of standards, codes, and guidelines as applicable.
• Seasoned knowledge of engineering standards and specifications and good knowledge of engineering software. Good working knowledge of English, both oral and written. HSE, TQM, and cost-conscious

Roles & Responsibilities:

• Perform conceptual, FEED, Studies, and detailed analyses and design as per design basis, project specifications, design codes, and standards.
• Prepare clear and accurate detailed design calculations and analyses, including design reports and procedures.
• Be fully familiar with the project scope of work, specifications, schedule, and all inter-discipline requirements, including identifying concerns as early as practicable and taking appropriate initiatives to address the issues.
• Identify changes to scope and promptly raise change notifications, including providing any necessary supporting documentation and estimates
• Provide similar support for Variation Orders.
• Maintain close coordination with other engineering disciplines, Planning, Fabrication, and Project Management Team, as required
• Prepare Discipline engineering design basis, philosophies, and technical specifications, as required.
• Provide technical direction and review of Designers producing products related to Instrumentation & Controls Engineering.
• Prepare and review design reports and procedures.
• Perform design verification through single-discipline check / inter-discipline check (IDC).
• Provide technical support to all fabrication queries, including identifying defect/rectification requirements.
• Prepare/review automation system definition, including philosophy, specifications, safety drawings, and system architecture.
• Prepare/review ESD logic (as applicable) / cause & effect diagrams and F&G logic (as applicable) / cause & effect diagrams.
• Prepare/update/review specifications and data sheets for Instrumentation & Controls equipment.
• Prepare / review I&C equipment spare parts lists.
• Prepare/review inputs to P&ID development and markups based on receipt of vendor information,